3 Series E90 320d (M47T2) SAL
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
When removing and installing the transmission, support the front
end of the engine at the housing with an installation aid
(e.g. transmission lifter).
Disconnect connector (1).
Unfasten screws.
Unscrew holder (2).
Tightening torque 23 00 1AZ
.
Supporting transmission:
Support with special tools 23 4 050 , 23 0 132 , 00 2 030 .
Secure transmission with tensioning strap (1).
Tasks are described in Transmission bracket.
After completion of work, check transmission oil level.
Remove screws and nuts.
Remove cross-member.
Tightening torque 23 71 1AZ/ 2AZ
RA Removing and installing transmission (GS6-37DZ) M47T2
BMW AG - TIS
23.01.2013 07:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
