3 Series E90 320d (M47T2) SAL
Release screw (1).
Tightening torque 23 00 1AZ
.
Unfasten screws.
Remove underbody protection (1).
Unfasten screws.
Tightening torque 23 00 1AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
RA Removing and installing transmission (GS6-37DZ) M47T2
BMW AG - TIS
23.01.2013 07:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
