3 Series E90 320d (M47T2) SAL
Unfasten screws.
Tightening torque: 26 11 1AZ
.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release screws.
Tightening torque: 26 11 6AZ
.
Bend propeller shaft downwards on center bearing.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Grip clamping sleeve (1).
Slacken nut (2).
Detach retainer (3) downwards using a screwdriver.
Pull cable (4) out of holder.
Installation:
Adjust selector lever
Crank engine at vibration damper in direction of rotation until
screw is visible in opening.
Release all bolts (1) of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 2 bolts.
Tightening torque 24 40 1AZ
.
RA Removing and installing automatic transmission (6HP19Z) M47T2
BMW AG - TIS
23.01.2013 08:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
