3 Series E90 320i (N43) SAL
Note:
The required parts are available from the BMW Parts Service
(ETK).
Remove screw caps (1) from injector (2).
Insert plunger.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
Remove flywheel again for sealing.
Drive in both nozzles (1) with special tool 11 9 360 on left and
right into crankcase.
Place injector (2) with Loctite sealing compound, manufacturer's
number 128357, on nozzle (1).
Slowly apply sealing compound with special tool 11 4 370 .
Slowly inject Loctite sealing compound (1) - manufacturer's
number 128357 - until it emerges from the grooves of front and
rear radial shaft seals.
RA Replacing all main crankshaft bearing shells (N43)
BMW AG - TIS
25.01.2013 03:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -