3 Series E90 320i (N43) SAL
Unfasten bolts and remove SAC clutch from flywheel.
Important!
Do not use a special tool to detach SAC clutch from flywheel.
Remove clutch plate (1) from flywheel.
Clean flywheel, check for wear and damage.
Replace damaged flywheel.
Check grooved ball bearing in crankshaft for ease of movement
and tightness and if necessary replace grooved ball bearing.
Important!
Always replace clutch plates fouled e.g. by oil, cleaning agent.
Check clutch disk for damage and friction rust in hub profile and
replace if necessary.
Check clutch disk for wear:
Measure lining protrusion at lining rivets at closing head (A) in
each case.
Note:
Rivet connection
a)
Closing head
b)
Swage head
Replace clutch plate if lining protrusion at closing head (A) is less
than 1 mm.
Push clutch disk onto the cleaned transmission input shaft and
check for easy movability.
RA Removing and installing/replacing clutch (SAC 228 N45/N46/N45T/N43/N46T)
BMW AG - TIS
25.01.2013 05:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -