3 Series E90 320i (N43) SAL
Release screws.
Tightening torque: 26 11 1AZ
Installation:
Replace self-locking nuts.
Grip propeller shaft firmly and release bolts (1).
Tightening torque: 26 11 6AZ
Bend propeller shaft downwards on centre bearing.
Detach propeller shaft from transmission flange and tie back to
side on vehicle underbody.
Release screws (1).
Remove heat shield (2).
Remove cables (3) from holder (120i and 320i only).
Note:
120i and 320i only
Cut through cable ties (1).
RA Removing and installing automatic transmission (6HP19Z) N43
BMW AG - TIS
25.01.2013 05:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -