3 Series E90 320i (N43) SAL
31 10 000
Removing and installing complete front axle
(with spring struts)
Warning!
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent
the vehicle from slipping off or tilting down.
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Mount securing fixture for vehicle on lifting platform
•
Secure engine in installation position
•
Disconnect battery negative lead
•
Remove both brake calipers from swivel bearing and tie up
•
Disconnect both plug connections for pulse generators and
expose lines up to holder on spring strut
•
Detach plug connection for brake pad sensor and expose
lines up to holder on spring strut
RA Removing and installing complete front axle (with spring struts)
BMW AG - TIS
25.01.2013 05:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -