3 Series E90 320Si (N45) SAL
Fit special tool 11 7 260 as illustrated.
Align locating bores of sensor gears to alignment pins on special
tool 11 7 260 .
Secure sensor gears with special tool 11 7 260 .
Screw special tool 11 7 260 to cylinder head.
Slacken screw (1) of exhaust adjustment unit by a half turn.
Slacken screw (2) of inlet adjustment unit by a half turn.
Fit socket on screws (1 and 2) and tighten by hand without
play.
Pretension clamping rail by turning adjusting screw with special
tool 00 9 250 or commercially available torque wrench to
0.6 Nm.
RA Removing and installing/replacing inlet and exhaust adjustment units (N40 / N45)
BMW AG - TIS
28.01.2013 07:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -