3 Series E90 320Si (N45) SAL
11 11 Engine block
Type
Thread
Tightening specification
Measure
1AZ Crankcase lower section to upper
section
N45 / 320si
M10x100
Replace, wash and oil
screws
Jointing torque
20 Nm
Torque angle
70
°
2AZ Crankcase lower section to upper
section
N45 / 320si
M8x40
Replace, wash and oil
screws
22 Nm
3AZ Crankcase lower section to upper
section
N45 / 320si
M8x26
Replace, wash and oil
screws
22 Nm
4AZ Screw plug / temperature sensor
N45 / 320si
M12x1.5
Replace seal.
22 Nm
5AZ Screw plug / water drain plug
N45 / 320si
M14x1.5
Replace seal
25 Nm
6AZ Screw plug / oil duct
N45 / 320si
M16x1.5
Replace seal
32 Nm
7AZ Plug
N45 / 320si
M22x1.5
Replace seal
50 Nm
8AZ Oil spray nozzles to engine block
N45 / 320si
12 Nm
9AZ Screw plug for assembly opening
N45 / 320si
M16x1.5
Replace seal
32 Nm
AZD Engine block
BMW AG - TIS
30.01.2013 09:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
