3 Series E90 325xi (N53) SAL
Unlock bearing pin (1) in direction of arrow and remove.
Lift out shift arm.
Installation:
Grease bearing pins (1).
Grease, refer to BMW Service Operating Fluids.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Slowly relieve tension on clutch slave cylinder otherwise air is
drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
Release screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws 23 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws 23 00 2AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate. Screw down aluminium screws according
to angle of rotation.
Angle of rotation 23 00 2AZ
.
RA Removing and installing transmission (GS6-37BZ) AWD N51/N52/N52K/N53
BMW AG - TIS
14.02.2013 19:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
