3 Series E90 325xi (N53) SAL
51 12 ...
Replacing trim on rear bumper (M Technic
aerodynamic kit)
Special tools required:
•
00 9 317
Necessary preliminary tasks:
•
Remove rear bumper trim
•
Remove bottom middle trim on rear bumper
Carefully heat trim (1) with hot air blower and detach with special
tool 00 9 317 from bumper (2).
Installation:
Minimum object temperature of trim and bumper
≥
18
°
C.
If this temperature is not achieved, the components must be
preheated.
For cleaning, use a fluff-free disposable cloth or a clean cleaning
cloth.
Clean adhesive area of bumper with spirit.
Air drying time at least 1 minute.
RA Replacing trim on rear bumper (M Technic aerodynamic kit)
BMW AG - TIS
15.02.2013 00:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -