3 Series E90 328xi (N52K) SAL
41 12 535
Replacing complete rear luggage
compartment floor (tail panel removed)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 12 535).
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Following new body parts are required (refer to EPC):
-
(1) Luggage compartment floor, left
-
(2) Frame side member, left
-
(3) Frame side member, top left
-
(4) Frame, luggage compartment floor
-
(5) Frame side member, top right
-
(6) Frame side member, right
-
(7) Luggage compartment floor, right
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cuts (1) at edge of 20 mm dia. bore.
Cut frame side member (2).
Installation:
Weld in reinforcement plates at severance cuts.
Open weld joints in areas (1).
Installation:
Weld new component in areas (2) additionally.
RA Replacing complete rear luggage compartment floor (tail panel removed)
BMW AG - TIS
18.02.2013 05:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -