3 Series E90 328xi (N52K) SAL
51 43 070
Removing and installing/replacing side trim
panel, footwell, on A-pillar, left (driver side)
Necessary preliminary tasks:
•
Remove front entrance cover strip (inside)
•
Remove trim panel for pedal assembly.
Detach mucket (1) in area of side trim panel (2).
Unscrew bolt (3).
Remove hood/bonnet release lever (4) from side trim panel (2).
Release screw (1).
Unclip side trim panel (4) in each case in direction of arrow at
retaining points (2 and 3).
If necessary, disconnect associated plug connection and remove
side trim panel (4).
Installation:
If necessary, lever out clips (1) remaining in bore.
If necessary, replace faulty clips (1).
Position side trim panel (2) preinstalled with clips (1) on
associated bores and clip into place.
Replacement:
Remove switch for unlocking rear lid.
RA Removing and installing/replacing side trim panel, footwell, on A-pillar, left (
BMW AG - TIS
18.02.2013 08:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -