3 Series E90 330i (N52) SAL
24 13 013
Replacing output flange shaft seal
(GA6HP19Z)
Special tools required:
•
23 0 020
•
24 2 351
•
24 2 352
•
24 2 353
•
24 2 370
•
24 2 380
Important!
After completion of work, check gear oil level.
Use only the approved gear oil.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Necessary preliminary tasks:
•
Remove underbody protection
•
Remove heat shields
•
Remove complete exhaust system
(N52/N52K/N54/M47T2/N47/M57T2)
•
Remove front or centre muffler (N46/N53)
•
Remove transmission cross-member
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
To rotate propeller shaft, unlock parking gear.
RA Replacing output flange shaft seal (GA6HP19Z)
BMW AG - TIS
19.02.2013 10:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -