3 Series E90 330i (N52) SAL
26 11 090
Removing and installing /replacing centering
mount for propeller shaft
Special tools required:
•
00 5 500
•
11 1 310
•
11 2 030
Necessary preliminary tasks:
•
Remove propeller shaft.
Fill centering bore (1) completely with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centering
bore.
The centering mount (1) is forced out of the propeller shaft by the
pressure on the grease filling.
If necessary, top up grease repeatedly.
Note:
To drive out the mount, you can also fill the centering bore
with water instead of grease.
Installation:
Remove grease/water from mount bore.
Drive in centering (1) with special tools 11 2 030 and 00 5 500
into propeller shaft (observe protrusion).
Grease centering mount.
RA Removing and installing /replacing centering mount for propeller shaft
BMW AG - TIS
19.02.2013 10:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -