3 Series E90 335xi (N54) SAL
Note:
Feed lines with soldered holder must be replaced by new version
with elastomer clamp holder. Observe installation position of fuel
low-pressure sensor. Lines for solenoid switches are laid behind
fuel line.
Install feed line (3).
In so doing, tighten screw connection hand-tight only
Important!
Follow sequence of screw connections:
1.
Tighten down nut (1) with special tool 13 5 020 .
Tightening torque 13 53 6AZ
.
2.
Tighten screw (2). Replace aluminium screw. Tightening
torque 13 53 9AZ
.
Assemble engine.
Check fuel system for leaks.
Check function of DME.
RA Removing and installing or replacing high-pressure fuel pump (N54, N53)
BMW AG - TIS
22.02.2013 10:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -