3 Series E90 335xi (N54) SAL
16 11 060
Removing and installing or replacing fuel
filler pipe
Recycling
Fuel escapes when fuel lines are detached. Have a suitable
collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Important!
Ensure adequate ventilation in the place of work!
Avoid skin contact (wear gloves)!
After installation of fuel tank/prior to first engine start-up:
•
Fill fuel tank with at least 5 litres of fuel.
•
Check ground connection at fuel filler neck to body for
continuity. If necessary, clean contact surface between
body and fuel filler pipe screw connection.
Necessary preliminary tasks:
•
Draw off fuel from fuel tank
•
Remove rear right wheel arch trim
•
Lower rear axle
Unhook retaining strap (1) from tank flap.
Open cap and set to one side.
RA Removing and installing or replacing fuel filler pipe
BMW AG - TIS
22.02.2013 11:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -