3 Series E90 335xi (N54) SAL
22 31 050
Replacing cross-member for transmission
mounting (AWD)
Necessary preliminary tasks:
-
Remove rear underbody protection
-
Remove centre muffler (E9x N53 only)
-
Remove exhaust system
-
Remove heat shields
-
Support transmission with workshop jack
Note:
Not M57T2
Release screws.
Remove exhaust system bracket (1).
Tightening torque 18 20 1AZ
.
Disengage cable for exhaust temperature sensor from holders on
transmission cross-member (N53 only).
Release screws.
Remove transmission cross-member.
Tightening torque 27 00 10AZ
.
RA Replacing cross-member for transmission mounting (AWD)
BMW AG - TIS
22.02.2013 12:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -