3 Series E90 335xi (N54) SAL
Coat top edge of rubber mount with Circo Light (refer to BMW
Parts Service).
Fit special tool 33 4 441 on rubber mount in such a way that
edge of rubber mount disappears in special tool.
Oil special tool 33 4 436 slightly before use.
Align special tool 33 4 140 by way of openings in rubber mount.
Note:
Ensure it is correctly supported on bearing bushing of rear axle
carrier.
Withdraw rubber mount from bearing bushing with special tools
33 4 436 , 33 4 437 , 33 4 140 and 33 4 431 .
Installation:
Coat new rubber mount with Circo Light (refer to BMW Parts
Service).
Oil special tool 33 4 434 slightly before use.
Assemble special tools 33 4 432 , 33 4 433 , 33 4 435 and
33 4 434 as illustrated.
Align rubber mount by way of arrow to direction of travel.
Draw in rubber mount as far as it will go.
After installation:
•
Bleed braking system
RA Replacing two rubber mounts (front) for rear axle carrier
BMW AG - TIS
22.02.2013 15:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -