3 Series E90 M3 (S65) SAL
Release bolts (1) on cylinder bank 2.
Remove timing case cover (2).
Installation:
Replace seal.
Important!
Both inlet and exhaust camshafts can be adjusted in the
1st cylinder firing TDC position .
Danger of mixing up both special tool bores.
The procedure for checking timing is different from that for
adjusting.
Crank engine at central bolt.
Secure crankshaft with special tool 11 5 320 in firing TDC
position of cylinder no. 1.
Position of inlet camshafts, cyl. 5-8, in firing TDC position of
cylinder no. 1.
Dihedron of inlet camshafts is vertical to cylinder axis,
letters/numbers on camshafts point upwards (E2).
RA Removing and installing/replacing left inlet VANOS gear (S65)
BMW AG - TIS
22.02.2013 10:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
