3 Series E90 M3 (S65) SAL
Important!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve can be damaged on constant-
velocity joint.
Grip propeller shaft at centre bearing and release screws.
Tightening torque, 26 11 6AZ .
Bend propeller shaft downwards at centre bearing.
Remove propeller shaft from transmission output flange and
detach constant-velocity joint from rear axle differential.
Installation:
Withdraw constant-velocity joint (1) up to stop.
Fit shims.
Attach propeller shaft with pulled-apart constant-velocity joint
to drive flange of rear differential.
Alternately tighten 2 opposing screws to draw constant-velocity
joint evenly into the input flange.
Replace ZNS bolts.
Tightening torque, 26 11 4AZ .
RA Removing and installing complete propeller shaft (constant-velocity joint)
BMW AG - TIS
22.02.2013 12:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
