3 Series E91 320d (M47T2) TOUR
Note:
The end cover is supplied in the set with a built-in radial seal
and a support bushing. The support bushing is fitted on the
radial seal (to provide protection during transportation and
storage).
Note:
When fitting the end cover with radial seal on the crankshaft, it
is only permitted to use the "support bushing (1)" as an
installation tool.
Lubricate contact face of crankshaft.
Important!
Push on end cover with support bushing (1) straight and
without tilting sideways.
Insert all screws and tighten down end cover.
Note:
Store support bushing (1) of new radial seal version as a
"special tool".
The old and new radial seal versions can be installed with the
support bushing (1).
Make sure dowel sleeves (1) are correctly seated.
Note:
Illustration shows connected segment gear.
RA Replacing crankshaft radial seal (M47TU / M47TU2)
BMW AG - TIS
22.01.2013 15:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
