3 Series E91 320d (M47T2) TOUR
Important!
Observe gap between special tool 33 4 420 and dust
plates.
To avoid grinding noises, make sure the dust plates are not
damaged (e.g. bent).
Support rear differential with workshop jack and special tool
33 4 420 .
Release screws (1).
Release nut and remove bolt (2) towards front.
Slowly lower workshop jack and remove rear differential towards
rear.
Important!
Adhere to the following installation sequence in order to
prevent distortion of the rear differential during installation and
thereby avoid potential complaints about noise.
Installation sequence:
1.
Install rear differential with workshop jack and special tool
33 4 420 .
2.
Insert bolts (1) (do not tighten down)
3.
Insert screw (2) from front and replace nut (do not tighten
down)
4.
Lower workshop jack
5.
Tighten screws (1)
Tightening torque 33 17 1AZ
.
6.
Tighten nut (2)
Tightening torque 33 17 1AZ
.
After installation:
•
Check rear differential oil level, correct if necessary
RA Removing and installing/replacing rear differential
BMW AG - TIS
22.01.2013 17:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -