3 Series E91 320i (N43) TOUR
65 77 016
Removing and installing/replacing airbag
control unit
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Warning!
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Disconnect battery negative lead and cover
•
Remove storage compartment
If necessary, remove foam cover from airbag control unit.
Disconnect plug connection (1).
Release screw (2) and nuts (3).
Tightening torque 65 77 1AZ
.
Installation:
Before screwing down airbag control unit (4), make sure negative
lead (5) is resting on associated threaded pin.
Remove airbag control unit (4) in direction of arrow.
RA Removing and installing/replacing airbag control unit
BMW AG - TIS
24.01.2013 17:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -