3 Series E91 320i (N43) TOUR
65 83 590
Removing and installing/replacing gyro
sensor drive for Car Communication
Computer
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove Car Communication Computer
If necessary, cut through warranty seal.
Release bolts (1).
Remove floor pan (2) towards bottom and set down.
Important!
Contact spring strip (3) on floor pan (2) must not be bent:
otherwise risk of short-circuiting!
When reinstalling floor pan (2), make sure individual springs
of contact spring strip (3) are correctly seated.
RA Removing and installing/replacing gyro sensor drive for Car Communication Comput
BMW AG - TIS
24.01.2013 17:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -