3 Series E91 323i (N52) TOUR
11 00 670
Securing engine in installation position (N52)
Special tools required:
•
00 0 200
•
00 0 202
•
00 0 204
•
00 0 208
•
11 0 000
Warning!
Risk of injury!
Observe following instructions relating to special tool:
1.
Prior to each use, check the special tools for defects,
modifications and operational reliability.
2.
Damaged/modified special tools must not be used!
3.
No changes or modifications may be made to the special
tools!
4.
Keep special tools dry, clean and free of grease.
Necessary preliminary tasks:
•
Secure engine bonnet/hood in service position
•
Remove cowl panel cover
•
Remove both tension struts from spring strut dome
•
Remove intake filter housing
•
Remove ignition coil cover
Release screws (1, 2).
Remove bulkhead (3).
Installation:
Make sure bulkhead is correctly seated.
M6x20 screw must be fitted in middle.
RA Securing engine in installation position (N52)
BMW AG - TIS
27.01.2013 19:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -