3 Series E91 323i (N52) TOUR
Carefully unclip door trim panel (1) at top from retainers (2) and
remove.
Disconnect plug on power window switch.
Unhook Bowden cable (1) from door lock (2).
Disconnect all plug connections and remove door trim panel.
Installation:
Make sure clips are installed in correct position.
Clips (1) are white.
Clip (2) is brown and shorter than clips (1).
If necessary, replace faulty clips.
Installation:
After assembling the door trim panel proceed as follows:
-
Open door window.
-
Lock with vehicle key.
-
Check for ease-of-movement on retaining button linkage
-
If necessary, align linkages
RA Removing and installing left or right rear door trim panel
BMW AG - TIS
28.01.2013 02:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -