3 Series E91 325d (M57T2) TOUR
32 34 020
Removing and installing/replacing airbag unit
Warning!
Observe the following instructions to avoid any risk of injury by
the airbag unit.
-
Comply with safety regulations for handling components
with gas generators.
-
Do not exert any force on the airbag unit.
-
Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag
unit and thereby cause serious injury.
Important!
Steering wheel must be replaced if airbag unit has been
triggered!
Follow procedure after airbag triggering.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Insert Torx screwdriver (T20) roughly straight from below into
opening on reverse side of steering wheel up to stop (approx.
5.5 cm).
Swing Torx screwdriver (T20) with handle sideways until airbag
unit is unlocked.
Repeat procedure on other side.
Installation:
Make sure electrical lead is correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in
direction of steering column shaft into steering wheel.
RA Removing and installing/replacing airbag unit
BMW AG - TIS
03.02.2013 05:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -