3 Series E91 325i (N52K) TOUR
52 13 455
Replacing heating elements for left or right
front seat (basic)
Necessary preliminary tasks:
•
Remove seat cover
Note:
Heating element is bonded to the foam section and cannot be
separated from each other without incurring damaging.
Foam section and heating mat must be replaced.
Check new foam section:
-
No obvious damage or material defects
-
All trim wires present in foam
-
No bubbles in foam section
-
No dirt/contamination on foam or residual foam
-
Pay attention to foam section on left and right
Check new heating mat:
-
No obvious damage or material defects
-
All tear-off film pieces presents
-
Note variant by examining label on cable
Guide cable for backrest heating through foam hole.
Stick on main section (1):
-
Pull adhesive film pieces off main section (1) and stick to
upper edge of main section foam until flush
Stick on bead section (2):
-
Pull adhesive film pieces off bead section (2) and stick on
heating mat along bead section edges.
-
Press down evenly in outwards direction
RA Replacing heating elements for left or right front seat (basic)
BMW AG - TIS
07.02.2013 01:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -