3 Series E91 325i (N52K) TOUR
66 31 006
Removing and installing (replacing) ACC
sensor
Necessary preliminary tasks:
•
Remove front bumper trim
Disconnect plug connection (1).
Turn plastic nuts (1) with a suitable tool through approx. 90
°
and
pull towards rear out of bracket (2).
Remove plastic nuts (1) from associated ball ends of ACC
sensor.
Installation:
Always replace plastic nuts (1).
Replacement:
Check preliminary adjustment of ACC sensor (1).
If necessary, carry out preliminary adjustment at retaining
pins (2).
•
Measurement A: 43
±
0.5 mm
RA Removing and installing (replacing) ACC sensor
BMW AG - TIS
07.02.2013 05:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -