3 Series E91 325xi (N52K) TOUR
34 00 009
Brake test on brake analyzer (test stand)
(AWD)
Note:
1.
Check tyres for damage
2.
Check tyre treads
3.
Check tyre pressure
Read and comply with notes on Brake testing instructions for E90
/ E91.
You must follow without fail the guidelines contained in the
operating instructions of the relevant test stand manufacturer.
Important!
Only brake test stands (analyzers) with test speeds of 2.5-
6 km/h may be used.
Before driving onto the brake test stand (dynamic brake
analyzer), switch off the Hill Descent Control (HDC) and
keep it switched off while testing the brakes.
The HDC indicator lamp must not light up!
Note:
It is possible for the HDC indicator lamp to go out or not to light up
even when HDC mode is activated if HDC is temporarily
unavailable on account of high operating temperature.
Important!
-
Vehicles with manual transmission and XDrive:
Do not select a gear and do not accelerate.
-
Vehicles with automatic transmission and XDrive:
Carry out brake testing with selector lever in N position
(Neutral) only.
Do not accelerate when the rollers start up.
Failure to comply with this instruction may result in damage to
the test stand or to the vehicle.
RA Brake test on brake analyzer (test stand) (AWD)
BMW AG - TIS
11.02.2013 15:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -