3 Series E91 330i (N52) TOUR
34 31 505
Removing and installing/replacing master
brake cylinder for DSC
Special tools required:
•
32 1 270
Necessary preliminary tasks:
•
Remove expansion tank.
•
Remove footwell trim.
•
Read and comply with General Information.
Important!
The brake booster must be slackened so that the brake
master cylinder can be removed and installed without tilting!
Remove locking clip (1) and disengage and pull out locking pin.
Slacken nuts (2).
Installation:
Replace self-locking nuts.
Tightening torque 35 11 1AZ
.
Important!
Do not bend brake lines.
Unfasten brake lines (1).
Installation:
Tightening torque 34 32 1AZ
.
Close off brake lines and brake master cylinder with plugs
32 1 270 .
If necessary, detach line (3) from hydraulic unit and press
downwards slightly.
RA Removing and installing/replacing master brake cylinder for DSC
BMW AG - TIS
18.02.2013 01:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -