3 Series E91 330i (N52) TOUR
67 62 020
Removing and installing/replacing flat motor
for rear left or right power window unit
Necessary preliminary tasks:
•
Remove rear power window unit
Release screws (1), tightening torque 51 35 1AZ
.
Detach flat motor for power window unit (2) in direction of arrow
from power window unit (3).
Installation:
Fit flat motor for power window unit (2) exactly on teeth of power
window unit.
Replacement:
A normalization must be carried out in order to activate anti-
trapping protection.
Operating sequence for normalization:
•
Operate corresponding power window switch in "Close"
setting.
•
Once the upper end position has been reached, hold power
window switch down for approx. 1 second more.
If necessary, repeat procedure again.
Normalization is thus completed.
Note:
Carry out function check (one-touch function, anti-trapping
protection and, if necessary, comfort function).
RA Removing and installing/replacing flat motor for rear left or right power window
BMW AG - TIS
18.02.2013 12:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -