3 Series E91 330i (N52K) TOUR
Preparation of new part:
Open weld joints in area (1).
Installation:
The cut part (2) is not needed.
Preparation of new part:
Open weld joints in area (1).
Mark severance cut (2) in accordance with vehicle and cut.
Installation:
Adjust new parts to fit with straightening attachment or universal
mount.
Before welding in, also adjust tail panel, rear lid and rear lights to
fit.
Weld new components in following order:
-
(1) Rear axle carrier
-
(2) Luggage compartment floor, upper section
-
(3) Support, frame side member
-
(4) Wheel arch, rear, inner half
Note:
Rear parcel shelf of Saloon and Coupé is shown removed for
purposes of clarity.
Installation:
For reasons of accessibility, the repair joining sequence differs
from the standard joining sequence.
Fit new component from above in area (1), adjust to fit and weld.
RA Replacing luggage compartment floor (complete with left or right inner wheel arc
BMW AG - TIS
18.02.2013 02:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -