Replacing Voltage Regulator for BMW 3 Series E92 316i (N43) COUPE
12 32 501
Replacing voltage regulator
Necessary preliminary tasks:
•
Switch off ignition
•
Disconnect battery negative lead
•
Notes on removing and installing electronic control units
•
Remove alternator
Bosch:
Release screws (1) and remove cover.
Bosch:
Release screws and remove control switch (1) upward.
Bosch:
Installation:
Clean contact surfaces and check pretension of contact
spring, replace regulator switch if necessary.
Measurement A = min. 5 mm.
Check collector ring for wear and recondition if necessary.
RA Replacing voltage regulator
BMW AG - TIS
20.01.2013 10:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
