3 Series E92 316i (N43) COUPE
First slide mounting sleeve 13 0 192 (large diameter) onto
injector (1).
Then slide mounting sleeve 13 0 193 (medium diameter) onto
injector (1).
Finally, press injector (1) into mounting sleeve
13 0 194 (small
diameter).
Installation:
Install injector within 10 minutes or slide on protective cap
(Fig. 13 14 05) (PTFE sealing ring swells up).
Installing injector
Installation of injector is described separately from removal.
Before installing injector in engines that have been run:
•
Clean contact surfaces of uncoupling elements (2) in
cylinder head.
•
Clean injector bore: To do so, preferably slide injector without
uncoupling element (2) but with new PTFE sealing ring (1) in
and out of injector bores several times.
The PTFE sealing ring must then be replaced.
•
Replace uncoupling element (2).
RA Removing and installing or replacing a fuel injector (N43)
BMW AG - TIS
20.01.2013 10:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -