3 Series E92 316i (N43) COUPE
41 21 930
Replacing inside left side frame (B-pillar
reinforcement)
Read contents of Body, General.
Use only approved spot-welding apparatus for repairs.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 21 930).
Place vehicle on straightening bench.
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Inner side frame
-
(2) Shaped part, B-pillar, inner (not shown)
-
(3) Shaped part, B-pillar, outer (not shown)
Mark severance cut in radius along line (1) and cut.
Important!
Cut outer metal sheet only.
Open weld joints in areas (2).
Cut reinforcement plate along line (1).
Measurement a = approx. 58 mm from bottom edge
In areas (2), the tube is welded from the rear.
In areas (2), mill holes each to approx. 13 mm and cut MAG weld
seams.
Installation:
Holes (2) are no longer welded.
RA Replacing inside left side frame (B-pillar reinforcement)
BMW AG - TIS
20.01.2013 13:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -