3 Series E92 320d (N47) COUPE
13 62 560
Removing and installing/replacing air-mass
sensor (N47)
Necessary preliminary tasks:
•
Read fault memory of DDE control unit.
•
Switch off ignition
•
Remove air filter housing upper section
Release screws (1) and remove air-mass sensor.
Tightening torque 13 71 3AZ
.
Note:
Check stored fault messages.
Now clear the fault memory.
Reset air-mass sensor adaptation with BMW diagnosis system.
RA Removing and installing/replacing air-mass sensor (N47)
BMW AG - TIS
21.01.2013 02:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -