3 Series E92 320d (N47) COUPE
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Twist in screw (2) and clamp down.
Then tighten down screw (1).
Note:
Illustration similar.
Release bolts and remove transmission.
Tightening torque, 24 00 1AZ
.
Note:
Illustration similar.
Installation:
Bore in driving disc must be accessible from opening on engine
oil sump.
Check dowel sleeves (1 and 2) for correct seating.
Replace damaged dowel sleeves.
Installation:
Rotate torque converter until bore in torque converter is flush with
bore in driving disc.
Flange automatic transmission to engine.
RA Removing and installing automatic transmission (6HP19Z) N47
BMW AG - TIS
21.01.2013 03:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
