3 Series E92 320d (N47) COUPE
33 41 005
Replacing left drive flange on rear axle shaft
Special tools required:
•
33 2 116
•
33 2 160
•
33 2 201
•
33 4 200
Necessary preliminary tasks:
•
Remove output shaft
•
Remove brake disk
•
Remove pulse generator
Force drive flange with special tools 33 2 116 / 33 2 201 ,
33 2 160 , 33 4 200 and 5 wheel bolts out of wheel bearing.
Note:
Rounded inside edge of special tool 33 2 160 must point to drive
flange.
Important!
The wheel bearing is destroyed when the drive flange is
removed and cannot be reused!
Replace wheel bearing.
Installation:
Install output shaft.
Oil drive flange lightly and attach to splines of output shaft.
Draw drive flange into wheel bearing.
RA Replacing left drive flange on rear axle shaft
BMW AG - TIS
21.01.2013 04:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -