3 Series E92 320d (N47) COUPE
34 51 527
Removing and installing or replacing DSC
hydraulic unit
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove lower section of microfilter housing
•
Extract brake fluid
Note:
Extract brake fluid out of expansion tank. Use a suction bottle
used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
After completing work:
•
Bleeding braking system
Important!
Do not mix up brake lines.
If necessary, mark before removal.
Close off connection bores with plugs.
Press cover (2) slightly to one side and disconnect plug
connection (1).
Unfasten brake lines (3).
Installation:
Tightening torque 34 32 1AZ
.
RA Removing and installing or replacing DSC hydraulic unit
BMW AG - TIS
21.01.2013 04:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -