3 Series E92 320d (N47) COUPE
51 14 011
Replacing rear BMW badge
Special tools required:
•
00 9 323
Important!
The Instructions on component cementing with double-sided
adhesive tape serve as the basis for this repair instruction and
must be observed without fail.
The BMW badge must be replaced after it is removed.
Removing badge:
Heat BMW badge (1) with hot air blower and carefully lever out
with special tool 00 9 323 .
Fitting badge:
Installation:
Grommets (1) must not be damaged.
Pull liner* off adhesive tape (2), position badge over guide
pins (3) and press down firmly.
* Liner is the protective film on a new badge.
RA Replacing rear BMW badge
BMW AG - TIS
21.01.2013 05:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -