3 Series E92 335xi (N54) COUPE
Rotate crankshaft at central bolt into TDC position.
Slide in special tool 11 0 300 in direction of arrow and block
crankshaft.
Important!
On engines with automatic transmissions, there is shortly
before the special tool bore for the TDC position a large bore
which can be confused with the special tool bore.
If the flywheel is secured in the correct bore with special tool
11 0 300 , the engine can no longer be moved at the central bolt.
Fit special tool 11 4 283 with screws (1).
Fit special tool 11 4 281 on special tool 11 4 283 .
Important!
If the special tool 11 4 281 cannot be installed, the camshaft
must be rotated at the hexagon head at the rear.
With 1st cylinder in firing TDC position, cams of exhaust
camshaft (2) and inlet camshaft (1) at 6th cylinder point
downwards at an angle.
Note:
If the timing is checked while the engine is installed, the position of
the camshaft can only be checked with a mirror.
Release central bolt (1) of exhaust camshaft.
Installation:
Replace screw (1).
Tightening torque: 11 36 1AZ
.
Release central bolt (2) of inlet camshaft.
Installation:
Replace screw (2).
Tightening torque: 11 36 1AZ
.
RA Adjusting camshaft timing (N54)
BMW AG - TIS
20.02.2013 05:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -