3 Series E92 M3 (S65) COUPE
13 62 029
Replacing suction pressure sensor on air
intake manifold (S65)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Remove intake air manifold
•
Remove secondary-air pump
•
Release cable duct for engine wiring harness; for information,
refer to Removing engine wiring harness
•
Remove idle actuator suction hose
Note:
The installation location for the intake manifold pressure sensor is
on the idle air duct at cylinder no. 8.
Unlock plug (1) and remove.
Release screws and pull suction pressure sensor (2) out of
intake air housing.
Tightening torque 13 41 1AZ
.
Installation:
Check sealing ring for damage, replace if necessary.
When installing, coat sealing ring with suitable antiseize agent.
RA Replacing suction pressure sensor on air intake manifold (S65)
BMW AG - TIS
21.02.2013 19:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -