3 Series E93 320i (N46T) CONVER
Slide open retaining clip (1) and unclip ball head.
Note:
Before removing, mark position of nuts to ensure correct
alignment when installing.
Unscrew nuts (2).
Tightening torque 54 37 08AZ
.
Installation:
Replace nuts.
Replacement only:
Screw on new fasteners loosely.
Fastener should still be able to be slid in order to centre itself.
Install roof shell without roofliner.
Close convertible top.
Fasteners glide into place.
Tighten down nuts (1).
Tightening torque 54 37 08AZ
.
Check gap dimensions and if necessary adjust
RA Removing and installing/replacing front cowl panel fastener
BMW AG - TIS
24.01.2013 01:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
