3 Series E93 320i (N46T) CONVER
Adjusting Hall sensor for roof module:
Loosely tighten screws (1) on holder.
Holder should still be able to be slid in order to centre itself.
Stow roof module.
The optimum position of the holders is determined by the
retraction of the centering pins into the fastener.
Tighten down screws (1).
Adjusting Hall sensor for convertible top compartment lid:
Insert screw (2) only loosely.
Pull back Hall sensor (1).
Important!
Risk of damage! Switch plate must not rest on Hall sensor.
Close convertible top compartment lid carefully.
Adjust Hall sensor (1) in relation to switch plate.
A) 0.4 mm
Tighten screw (2).
Check function of Hall sensor.
If necessary, reduce gap between Hall sensor and switch plate.
RA Replacing rear-end module Hall sensor on partition wall
BMW AG - TIS
24.01.2013 02:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
