3 Series E93 325d (M57T2) CONVER
Preparation of new part:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (1).
Preparation of new part:
Open weld joints in areas (1).
Installation:
The parts (2) separated by cutting are still needed.
Preparation of new part:
Open weld joints in area (1).
Mark severance cut (2) in accordance with vehicle and cut.
Installation:
Adjust new parts to fit with straightening attachment or universal
mount.
Before welding in, also adjust tail panel, rear lid and rear lights to
fit.
Weld new components in following order:
-
(1) Rear axle carrier
-
(2) Luggage compartment floor, upper section
-
(3) Support, frame side member
-
(4) Wheel arch, rear, inner half
-
(5) Mounting, rollover protection (not shown)
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
26.01.2013 00:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -