3 Series E93 325d (M57T2) CONVER
52 14 030
Removing and installing/replacing backrest
frame on left or right front seat
Necessary preliminary tasks:
•
Remove backrest cover
•
Remove seatback release
•
Remove microswitch.
•
Remove coupling gear
Note:
Before removing the backrest, it is essential to move the backrest
forwards:
Tunnel side:
Release screw (1).
Installation:
Screw (1) must be replaced.
Tightening torque 52 10 07AZ
.
Door side:
Release nut on opposite side from stud (1).
Drive out stud (1) with plastic mallet.
Installation:
Stud (1) and nut must be replaced.
Tightening torque 52 10 08AZ
.
Remove backrest frame from seat mechanism as follows:
Lever tunnel-side backrest frame with screwdriver over bushing.
Then remove backrest frame in upward direction by pulling with
alternate movements.
Tunnel-side plastic bushing (1) must not be damaged.
RA Removing and installing/replacing backrest frame on left or right front seat
BMW AG - TIS
26.01.2013 09:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -