3 Series E93 325d (M57T2) CONVER
Remove remnants of adhesive from roof shell.
Clean adhesive area with Isohexane.
Air drying time:
≥
1 minute
Important!
Adhesive area must be dry and free from dust and grease.
Once it has been cleaned, do not touch the adhesive area
with bare hands.
Use 4 mm and 7 mm dia. butylene thread (see BMW Parts
Service).
Use 1.5 mm x 15 mm butylene flat tape (see BMW Parts
Service).
Overview of butylene thread laying on front roof shell, side:
1.
Apply 4 mm dia. butylene thread up to middle of threaded
bushes in sheet metal groove.
2.
Laying on front roof shell area, see below.
3.
Laying on rear roof shell area, see below.
Butylene thread resting on threaded bushes.
Overview of butylene thread laying on front roof shell, rear
left/right:
1.
Apply 7 mm dia. butylene thread from middle of threaded
bushes rising slightly.
Installation:
Connect and smooth butylene thread joints with plastic wedge.
Overview of butylene thread laying on front roof shell, rear
left/right:
1.
Apply 7 mm dia. butylene thread from middle of threaded
bush rising slightly up to elongated hole.
2.
Allow butylene thread to run out thinner closed around
elongated hole.
RA Replacing front roof shell seal
BMW AG - TIS
26.01.2013 10:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -