5 Series E34 518g (M43) TOUR
Rotate engine from position of 45
°
before TDC in direction of
rotation to TDC position.
Secure crankshaft in TDC position with special tool 11 2 300.
Caution!
Remove special tool 11 2 300 before starting engine.
Mount chain on chain wheel.
Carefully and slowly push back tensioning rail at hexagon and fit
chain wheel with chain.
Note:
Arrow on chain wheel in cylinder axis points upwards; align
elongated holes in centre.
Install screws and tighten down chain wheel.
Tightening torque,
refer to Technical Data 11 31 3AZ.
Remove special tools 11 2 300 and 11 3 190.
Assemble engine.
RA Removing and installing/sealing cylinder head (M43)
BMW AG - TIS
15.01.2013 12:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -